- Tree seeds
- Shrub seeds
- Flower seeds
- Herb seeds
- Climber & Vine seeds
- Ornamental Grass seeds
- Houseplant seeds
- Seeds by growing rate
- Seeds by plant hardiness
- Seeds by sowing time
- Seeds by Type
- Seeds of plants for special use
- For Germination & Propagation
- Almost FREE
About the product
Tree native to the highlands of Mexico. It does not stand long periods of temperatures as low as –10C, but resists occasional brief below zero dips. It is moderately drought-tolerant, in this scope is superior than Pinus taeda.
It has been introduced near sea level in New South Wales, Australia, where it spreads naturally by wind and is very favored because rainfalls are more abundant in summer. It was also introduced in New Zealand for commercial purposes and is fully naturalized there. It is cultivated in the United Kingdom as an ornamental tree for parks and gardens, and has gained the Royal Horticultural Society's Award of Garden Merit.
The timber is pale-pink to salmon, moderately soft, brittle and smelling strongly of aniseed when freshly cut.
Thrives in a light well-drained sandy or gravelly loam. Dislikes poorly drained moorland soils. Established plants tolerate drought. This species is not hardy in the colder areas of the country, it tolerates temperatures down to between -5 and -10°c. Plants usually form multi-stemmed trees in Britain due to frost damage. Early growth is quite rapid. This species is cultivated for its timber in warm temperate areas but is not very suitable for Britain. Plants grow well in Cornwall (where there are specimens more than 15 metres tall) and in other areas with similar climate. The cones open and shed their seed whilst still attached to the tree. Plants are strongly outbreeding, self-fertilized seed usually grows poorly. They hybridize freely with other members of this genus. Leaf secretions inhibit the germination of seeds, thereby reducing the amount of plants that can grow under the trees. This species is notably resistant to honey fungus.
Genus - Pinus
Species - Patula
Common name - Mexican weeping pine
Pre-Treatment - Required
Hardiness zones - 8 - 10
Height - 164' / 50 m
Plant type - Tree
Vegetation type - Evergreen
Exposure - Full Sun
Growth rate - Medium
Soil PH - Acidic, Neutral
Soil type - Light (sandy), medium (loamy), heavy (clay)
Water requirements - Drought tolerant, average water
Landscape uses - Woodland Garden Canopy; Sunny Edge
Leaf / Flower color - Green / --
1. Place the seeds in a container with tepid water and soak them for 24 hours. Change the water and wait another 24 hours.
2. Put the seeds in a small plastic bag and cover with damp sand. Place the bag holding the seeds in the refrigerator for one month to stratify the seeds, which is preserving seeds in layers of moisture-laden peat, soil or sand. Check the sand and water as needed to maintain moisture. Don't allow the seeds to get soaked.
3. Fill small pots with compost. Place one or two pine seeds on top of the compost in each pot, then cover the seeds with 5 mm layer of sand.
4. Water the sand and compost to add moisture, then place the pots in a warm, sunny location. As the seedlings emerge and grow, the soil needs to remain moist, not wet.
5. Repot the pine trees into medium-sized pots in the fall. Grow them in the pots for the following season until they are large and strong enough for transplanting into the landscape.